Product ID:CHEMGLO II ALKYD ENAMEL, BA-2400
MSDS Date:08/25/1992
FSC:8010
NIIN:00N068902
MSDS Number: CBJRJ

WATTYL PAINT CO

5275 PEACHTREE INDUSTRIAL BLVD
ATLANTA, GA 30341
US

Emergency Phone: 404-455-7000

Info Phone: 404-455-7000

Cage: JO286

WATTYL PAINT CORP

ATLANTA, GA 30341 US

Telephone: 404-455-7000

Cage: WATTL

2.

CAS: 8052-41-3

RTECS: WJ8925000

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM; 9495

HOWEVER, PRECAUTIONS IN SPECIAL PROTECTION INFO

RTECS: 9999999ZZ

BE USED IF THE DRIED COATING IS SANDED OR ABRADED IN

RTECS: 9999999ZZ

ANY TLV LISTED IN INGREDIENTS SECTION MAY BE EXCEEDED,

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHALATION:ANESTHETIC.
IRRITATION OF THE RESPIRATORY TRACT, OR ACUTE NERVOUS SYSTEM
DEPRESSION CHARACTERIZED BY THE FOLLOWING PROGRESSIVE STEPS:
HEADACHE, DIZZINESS, STAGGERING GAIT, CONFUSION, UNCONSCIOUSNESS
OR COMA. SKIN OR EYE CONTACT:PRIMARY IRRITATION. CHRONIC: MAY CAUSE
RESPIRATORY AND/OR(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:SKIN SENSITIZATION. PERMANENT CENTRAL
NERVOUS SYSTEM CHANGES DUE TO SOLVENT OVEREXPOSURE HAVE BEEN
REPORTED.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHAL:REMOVE FROM EXPOS. RESTORE BRTHG. TREAT
SYMPTOMATICALLY. CONSULT MD. EYES:FLUSH IMMED W/LRG AMTS OF H*2O
FOR AT LEAST 15 MIN. TAKE TO MD FOR MED TREATMENT. SKIN:WASH
AFFECTED AREAS OF SKIN W/SOA P & H*2O. REMOVE DRENCHED CLTHG.
CONSULT MD IF IRRIT PERSISTS. INGEST:DRINK 1 OR 2 GLASSES OF H*2O
TO DILUTE. DO NOT INDUCE VOMIT. CONSULT MD/POIS CTL CTR AT ONCE.
TREAT SYMPTOMATICALLY.

Flash Point:100F,38C
Lower Limits:1.0%
Extinguishing Media:USE NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
CLASS B EXTING/EXTINGUISHING AGENT DESIGNED TO EXTING FLAMM LIQUID
FIRE.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD. ISOLATE FROM
HEAT, ELEC EQUIP, SPARKS & OPEN FLAME. CLSD CNTNRS MAY EXPLODE WHEN
EXPOSED TO EXTREME HEAT. APPLICATN TO HOT (SUPDAT)

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION (FLAME, HOT
SURFACES, AND ELECTRICAL, STATIC OR FRICTIONAL SPARKS). AVOID
BREATHING VAPORS. VENTILATE AREA. CONTAIN AND REMOVE WITH INERT
ABSORBENT AND NON-SPARKING TOOL S.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LARGE
QUANTITIES ONLY IN BUILDINGS DESIGNED TO COMPLY WITH OSHA 1910.106.
CLOSE CONTAINER AFTER EACH USE.
Other Precautions:DO NOT TAKE INTERNALLY. OBSERVE GOOD SANITARY
PRACTICES. NOTE:PIGMENTED PAINTS & COATINGS (THOSE WHICH ARE
OPAQUE, COLORED/WHICH HAVE REDUCED GLOSS WHEN DRY) MAY CNTN MATLS
SUCH AS SILICA, TALC, CALCI UM CARBONANTE, TITANIUM (SUPDAT)

Respiratory Protection:IF SPRAYED IN AREAS W/UNRESTRICTED VENT, USE
NIOSH/MSHA APPRVD MECH FILTER TO REMOVE OVERSPRAY; IN RESTRICTED
AREAS USE APPRVD CHEM/MECH FILTER TO REMOVE BOTH PARTICLES & VAP.
FOR ANY METHOD OF APPLIC ATION IN CONFINED AREAS WHERE (ING 4)
Ventilation:PROVIDE SUFFICIENT VENT IN VOLUME & PATTERN, TO INSURE VAP
CONCS WELL BELOW ANY TLV & LEL LISTED IN SECTION II AND IV.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXPLO HAZ:SURFS REQS SPECAL PRECS. DURING EMER SITUATIONS OVER-EXPOS TO
DECOMP PRODS MAY CAUSE HLTH HAZ. SYMPS MAY NOT BE IMMED APPARENT.
OBTAIN MED ATTN. OTHER PREC:DIOXIDE, ETC. WHICH ARE HAZ TO INH ALE
IN DRY POWDER FORM. THESE HAZS ARE NOT BELIEVED TO BE PRESENT WHEN
POWDERS ARE DISPERSED IN LIQUID COATING.(ING 2)

Boiling Pt:B.P. Text:>300F,>149C
Vapor Pres:SEE ING
Vapor Density:HVR/AIR
Spec Gravity:0.996-1.2
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:53-70

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS.
Stability Condition to Avoid:HIGH TEMPERATURES.
Hazardous Decomposition Products:WHEN HEATED TO DECOMPOSITION, AS IN A
FIRE OR IN WELDING, MAY PRODUCE TOXIC FUMES SUCH AS CARBON
MONOXIDE.

Waste Disposal Methods:DISPOSE IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS. INCINERATE IN APPROVED FACILITY. DO NOT
INCINERATE CLOSED CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.